Second, enamel reactor Installation Notes 1) must be checked before installation of the components are complete, if the defect promptly replaced. 2) direct contact with the installation process rigorous crowbars, hammers and other hand-collision enamel pieces, so as not to damage the enamel lining. 3) bearing device can only be used in the lifting process, the rings enamel reactor force role, are not allowed to take over, clips, nozzle and other weak parts by force, to light from the light up to avoid hitting the town, but not hammering tank. 4) set up the device before installing the enamel surface should be clean water, wear clean shoes inside view into the glass lining is intact. 5) enamel equipment fastening flanges and take over parts of the reactor, chemical containers should follow the installation guidelines, requiring symmetrical, evenly and gradually tightened, so as to avoid excessive force resulting in partial damage to the enamel surface. In the demolition process, such as loss of elasticity found gasket should be replaced. 6) clamp devices is one of the main pressure components, in addition to the requirements of the installation process even by force outside its enamel reactor size, but also to ensure its quality and quantity of enamel reactor price, must with residual or decrement installation. 7) reaction of endoscopic irrigation installed glass is a brittle material, except when installed to ensure uniform tightening, the clamping force is not too large. Such as local leak stopper partial pad should avoid excessive local stress fracture occurred. 8) enamel reactor stirrer installation, you should pay attention to the assembly locking pin or lock nut locking pieces, and check the direction of rotation of the agitator is consistent with the direction shown, so as not to run off and smashed reverse stirrer lining. 9) as a metal component on the enamel reactor, only allowed outside the jacket and other non-enamel surface welding, welding faster, and take appropriate measures to cool, if nozzle inlet, near the flange Shi Welding should be closely covering all nozzle to avoid damage to the enamel surface welding slag splashing. 10) After the equipment is installed, to deal with various components and the tank but check before proceeding with an empty test and correct turn. Enamel enamel reaction tank has three requirements: 1. have a good glass-lined insulation, when the thickness of the glass-lined within the prescribed high frequency spark examination 20KV porcelain layer, high-frequency spark breakdown ceramic layer can not. 2. The internal stress of the glass layer is smaller, the better the elasticity, the greater the hardness, flexural compressive strength is higher, the impact resistance, the better. Glass layer within the specified thickness, with a diameter of 30mm, weight 112g ball at impact, the impact energy is 28210-3J. 3. Glass ceramic layer thickness 0.8-2.0mm, glass-lined equipment attachments porcelain thickness of 0.6-1.8 mm. enamel reactor price, enamel reactor, Zibo Chemical Equipment Co. lining provided by Zibo Chemical Equipment Co. lining. Zibo Chemical Equipment Co. lining (www.zibogongtang.cn) strong, credible, Shandong Zibo glass industry equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead lining Zibo Chemical Equipment Co., and you hand in hand into the brilliant, for a better future!