Q235 steel enamel and have similar thermal expansion, so in the chemical industry can withstand the thermal shock. As we all know, the enamel has good acid and alkali resistance, and compared with the specifications of pure stainless steel products is very low cost, which are widely used. Second, enamel reactor Installation Notes 1) must be checked before installation of the components are complete, if the defect promptly replaced. 2) direct contact with the installation process rigorous crowbars, hammers and other hand-collision enamel pieces, so as not to damage the enamel lining. 3) bearing device can only be used in the lifting process, the rings reaction force enamel tank maintenance, are not allowed to take over, clips, nozzle and other weak parts by force, to light from the light up to avoid hitting the town, but not hammering tank body. 4) set up the device before installing the enamel surface should be clean water, wear clean shoes inside view into the glass lining is intact. 5) equipment and take over parts of the fastening flange, chemical containers should follow the installation guidelines, requiring symmetrical, evenly and gradually tightened, so as to avoid excessive force resulting in partial damage to the enamel surface. In the demolition process, such as loss of elasticity found gasket should be replaced. Kazi 6) devices are one of the main pressure components, in addition to the installation process requires its reaction force uniform outer enamel tank accessories, but also to ensure its quality and quantity, must be installed with a disability or reduction. 7) reaction of endoscopic irrigation installed glass is a brittle material, except when installed to ensure uniform tightening, the clamping force is not too large. Such as local leak stopper partial pad should avoid excessive local stress fracture occurred. 8) enamel reactor stirrer installation, you should pay attention to the assembly locking pin or lock nut locking pieces, and check the direction of rotation of the agitator is consistent with the direction shown, so as not to run off and smashed reverse stirrer lining. 9) If the settings on the enamel reactor metal components, allowing only non-enamel outer surface of the jacket, etc. Shandong enamel reaction tank welding, welding faster, and take appropriate measures to cool, if nozzle inlet, flange near the welding should be closely covering all nozzle, to avoid damage to the enamel surface welding slag splashing. 10) After the equipment is installed, to deal with various components and the tank but check before proceeding with an empty test and correct turn. Zhengzhou enamel lining reaction tank _ Zibo Chemical Equipment Co. _ enamel pot reaction by Zibo Chemical Equipment Co. lining. Zibo Chemical Equipment Co. lining (www.zibogongtang.cn) is an industry leader in Shandong Zibo, glass industry and special equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Boring in Zibo Chemical Equipment Co. led the staff warmly welcome all inquiries negotiations to create Zibo Chemical Equipment Co., lining a better future.